Verschillen

Dit geeft de verschillen weer tussen de geselecteerde revisie en de huidige revisie van de pagina.

--- li_cli_netdiscover [2014/04/02 16:07] – aangemaakt admpvi
+++ li_cli_netdiscover [Ongeldige datum] (huidige) – verwijderd - Externe bewerking (Ongeldige datum) 127.0.0.1
@@ Regel 1: / Regel 1: @@
-====netdiscover====
-=== Usage ===
-Command line usage & parameters:\\
-Usage: netdiscover [-i device] [-r range | -p] [-s time] [-n node] [-c count] [-f] [-S]\\
-  -i device: your network device
-  -r range: scan a given range instead of auto scan. 192.168.6.0/24,/16,/8
-  -p passive mode do not send anything, only sniff
-  -s time: time to sleep between each arp request (miliseconds)
-  -c count: number of times to send each arp reques (for nets with packet loss)
-  -n node: last ip octet used for scanning (from 2 to 253)
-  -S enable sleep time supression betwen each request (hardcore mode)
-  -f enable fastmode scan, saves a lot of time, recommended for auto
-If -p or -r arent enabled, netdiscover will scan for common lan addresses
-On screen usage keys:
-  h      Show help screen
-  j      Scroll down (or down arrow)
-  k      Scroll up (or up arrow)
-  a      Show arp replys list
-  r      Show arp requests list
-  q      Close help screen or end application
-**Some examples of usage**\\
-Scan a class C network, to see wich hosts are up
-   # netdiscover -i wlan0 -r 192.168.1.0/24
-Scanning /16 network, trying to find online boexes
-   # netdiscover -i wlan0 -r 192.168.0.0/16
-Scan a class A network, trying to find network addresses
-   # netdiscover -i wlan0 -r 10.0.0.0/8
-Auto scan common networks
-   # netdiscover -i wlan0
-Dont send arp requests, listen only
-   # netdiscover -i wlan0 -p
-If you want to change your mac address for the scan, try:
-   # ifconfig wlan0 down
-   # ifconfig wlan0 hw ether 00:11:22:33:44:55
-   # ifconfig wlan0 up
-   # netdiscover -i wlan0 [options]